Teledyne LeCroy ArbStudio User Manual

Page 162

Text mode
Original mode

ArbStudio

154

922244-00 Rev A

5. On the The DEV1 Settings Ch 1 pop-up screen's Run Mode tab,

select Continuous and press OK.

When the instrument starts, the Continuous Mode repeats all of
your waveforms entered into the sequencer (previously during step
3) until you press the Force Stop button.

6. Now, press the Run/Stop button on the ARBStudio toolbar.

The software loads the settings and the waveforms into the
ArbStudio 1102/1104 instrument and starts generating the
waveforms.

7. Your sequence of waveforms is generated on the CH1 BNC output.

You can connect an oscilloscope to this output and analyze the
signal.

8. Stop generating waveforms by pressing the Run/Stop button again

or the Force Stop button (also on the ARBStudio toolbar).