Teledyne LeCroy ArbStudio - Manual (Page 12)

ArbStudio
4 922244-00 Rev A

Observe all terminal ratings. Do not apply a voltage to any input
that exceeds the maximum rating of that input. Refer to the front of
the instrument for maximum input ratings.

Use only within operational environment listed. Do not use in wet
or explosive atmospheres.

Use indoors only.

Keep product surfaces clean and dry.

Do not block the cooling vents. Leave a minimum six-inch (15 cm)
gap between the instrument and the nearest object. Keep the
underside clear of papers and other objects.

Do not remove the covers or inside parts. Refer all maintenance to
qualified service personnel.

Do not operate with suspected failures. Do not use the product if
any part is damaged. Obviously incorrect measurement behaviors
(such as failure to calibrate) might indicate impairment due to
hazardous live electrical quantities. Cease operation immediately
and sequester the instrument from inadvertent use.
Operating Environment
The instrument is intended for indoor use and should be operated in a
clean, dry environment. Before using this product, ensure that its operating
environment is maintained within these parameters:
Temperature: 0 °C to 50 °C
NOTE: Power Supply Adapter for ArbStudio 1104 is rated for 40 °C max.
Humidity: Maximum relative humidity 80% (non-condensing) for
temperatures up to 40 °C decreasing linearly to 50 % relative humidity at
50 °C.
Altitude: Up to 10,000 ft (3,048 m) at or below 30 °C.