beautypg.com

Operator’s manual – Teledyne LeCroy ArbStudio User Manual

Page 131

background image

Operator’s Manual

922244-00 Rev A

123

B

Instruction

Explanation

Parameters

Load Event Mask

Load the mask value

Event Mask (HEX): the value of the
mask. Loop Mode: NO LOOP,
LOOP BEGIN (it marks the first
instruction of a loop), LOOP END (it
marks the last instruction of a loop).

Wait Event

Wait until the event
occurs

Input Event (HEX):16 bits input
event. Input Event[14..0] are
DPIO[14..0], Input Event[15] is the
trigger event (please see Trigger
Module for description).The Input
Event bits are masked logically in
AND with Mask value. The event
occurs if:Input Event AND Input
MASK = Input Group Value Loop
Mode: NO LOOP, LOOP BEGIN (it
marks the first instruction of a loop),
LOOP END (it marks the last
instruction of a loop).

Reset Trigger
Event

Reset the trigger event
value

Loop Mode: NO LOOP, LOOP
BEGIN (it marks the first instruction
of a loop), LOOP END (it marks the
last instruction of a loop).

PLEASE NOTE THE FOLLOWING:

The last sequencer instruction must be RETURN.

REPEAT WAVEFORM: the generated vectors are asynchronous
respect to the clock generator signal.

SYNC REPEAT WAVEFORM: the generated vectors are synchronous
respect to the clock generator signal. Sync signal can be delayed
with Sync Delay.

Sequencer Memory depth is 1024 instructions.

Waveforms Memory depth is 1048576.

A block of instructions can be repeated with Loop Begin / Loop End
parameters. Loop Begin marks the first instruction of the loop, Loop
End marks the last instruction.
LOOP REPETITIONS parameter is the number of times that the loop
will be repeated. Allowed values are from 1 to 8191.

Add an operation to the sequencer by selecting the operation in the
Operation List tab, and then pressing the Add button.