Teledyne LeCroy ArbStudio - Manual (Page 183)

Operator’s Manual
922244-00 Rev A 175
B
Creating Digital Waveforms
The ArbStudio 1102/1104 may optionally be configured to work as a
powerful Digital Pattern Generator-Sampler.
When the ArbStudio 1102/1104 runs in this mode it can emulate standard
serial or parallel bus transitions or custom digital interfaces for system
debugging and characterization. Based on a vector/command memory, its
architecture also includes a powerful sequencer defining the
vector/command execution flow.
NOTE: The following steps are done on an ArbStudio 1104 with the Pattern
Generator option enabled.
A workspace with Pattern Generator as the operating mode must first be
created in order to create Digital Waveforms.
If you already have a workspace open, be sure it meets the
aforementioned requirements before proceeding with the following steps:
1. Double click the Signals Definition under Pod A on the Device
Control Tree.
2. The DEV1 Waveform Sequencer Pod A pop-up screen is shown.