Teledyne LeCroy ArbStudio - Manual (Page 114)

ArbStudio
106 922244-00 Rev A
11. Double click the Waveform Sequencer on the Pod A Control
navigation tree.
12. Click the Add Waveform button to add a digital waveform in the
Waveform List.
13. The New Waveform screen is shown. Click the Add All button to add
all the buses/signals to the digital waveform.
14. Now, click the OK button to add Waveform1 to the Waveform List.
15. Press the Edit Waveform button or double click on Waveform1 to
open the Editing waveform screen.
Use the clock editor and the counter editor to define the CLK and DATA
waveforms. Define the WR/RD/WriteRAM signals making graph selections
and clicking the To 1 button. Set to 1 the WriteRAM signal if you want to
acquire data with the Pattern Generator. Set to HiZ to change the pin
directions from output to input. Click OK to confirm.