The state listing screen – Teledyne LeCroy ArbStudio User Manual
Page 138

ArbStudio
130
922244-00 Rev A
to the desired position in the list. You can also insert a signal or bus on the
list or remove one from the list.
R
ESIZING
S
IGNAL
A
MPLITUDE
Resize the signal amplitude by dragging the line between a signal name cell
inside an expanded bus on the left of the Waveform View screen.
To the right of every signal or bus name, a number indicates the value the
signal or bus assumes at the time position of the master cursor.
R
IGHT
C
LICK
M
ENU
Right clicking on the signal name column shows the right click menu with
the following options:
Add samples scale - Select this option to add a signal (indicated by
the Add samples scale icon) with a series of segments that
represents the number of samples.
Analog mode display - This option (available only for the buses) will
represent a bus as an analog waveform.
This is useful for example if an ADC or a DAC has to be tested.
Add-Remove signals - This option allows adding or removing signals
to the Waveform View.
A
DDITIONAL
T
OOLS
Using Zoom, Cursors, Graph Property, and Search tools on the toolbar are
done the same way as previously described in the Digital Waveform Editor
section.
The State Listing Screen
The State Listing screen shows acquired data numerically in columns, each
one representing a signal or a group of signals. Additional columns indicate
the sample number (Samples column), the absolute time (Time column)
and the interpretation of the serial protocol bus operations (if the trigger
option has been selected).
Access the State Listing screen, by double clicking State Listing from the
Device Control tree.