Teledyne LeCroy ArbStudio - Manual (Page 123)

Operator’s Manual
922244-00 Rev A 115
B
To the right of every signal or bus name, a number indicates the value the
signal or bus assumes at the time position of the master cursor.
Right Click Menu
Right clicking on the signal name column shows the right click menu with
the following options:

Add samples scale - Select this option to add a signal (indicated by
the Add samples scale icon) with a series of segments that
represents the number of samples.

Analog mode display - This option (available only for the buses) will
represent a bus as an analog waveform.
This is useful for example if an ADC or a DAC has to be tested.

Waveform View Settings... - This option opens the Signal Property
screen.

LSB on Top - Bus values are calculated with MSB (Most Significant Bit
on Top) by default. Select LSB to have the Least Significant Bit on
Top instead.
Digital Waveform Editor Toolbar
This toolbar contains several commands for use on digital waveforms as
follows:

Signal/bus to 0.

Signal/bus to 1.

Signal/bus to High Impedance.