Teledyne LeCroy ArbStudio - Manual (Page 31)

Operator’s Manual
922244-00 Rev A 23
B
7. Status Bar - This are of the screen provides channel/pod run mode
status information as follows.

Initializing - The software is loading the firmware into the
instrument.

Ready - The instrument is ready to start.

Running - The ArbStudio hardware is running.

Stopped - The instrument is stopped.

Demo - The software is in demo mode.
PLEASE NOTE THE FOLLOWING:

When you press the Run/Stop button, the output log displays the
operation list the software is performing as it loads the waveforms
and settings into the instrument. If any operations cause an error or
a problem in the sequencer while loading, the log notifies you.

All of the panels are dockable; meaning they snap into convenient
screen positions adjacent to other panels. Move individual panels by
clicking the panel's top side, holding, and dragging with your mouse.
Setup Examples and Common Tasks
Overview
The following examples provide a quick way to learn standard ArbStudio
signal setups and common tasks:
1. Creating a New Workspace (on page 24)
2. Opening an Existing Workspace (on page 26)
3. Arbitrary Waveform Generator Setup Example (on page 27)
4. Digital Sampler Setup Example
In addition to the Setup Examples and Common Tasks, the end of this
manual also contains scenarios with detailed steps for performing typical
tasks and setups using ARBStudio as shown in the How do I section on the
Welcome screen (shown when first launching the software).