Teledyne LeCroy ArbStudio - Manual (Page 116)

ArbStudio
108 922244-00 Rev A
18. Press the Run/Stop button on the ArbStudio toolbar.
The software loads the settings and the digital waveforms into the
ArbStudio instrument and starts generating waveforms.
19. Waveform1 is then generated on the Pod A probe. You can connect
a logic analyzer to the probes to analyze the generated signals.
20. Stop the digital waveform generation by clicking the Run/Stop
button again.
21. Double click Waveform View or State Listing on the Device Control
tree to analyze the acquired data.