Teledyne LeCroy ArbStudio - Manual (Page 147)

Operator’s Manual
922244-00 Rev A 139
B
Signals Description (Pattern Generator, Optional)
The signals available on ArbStudio 1102D/1104D Pattern
Generator/Sampler connectors are reported as follows:
Signal Name Type Description
DGND Digital ground
DP[0..17] Input
Output Digital pattern generator bidirectional pins
DP[15] / CLK Input /
Output Clock generator module output pin or
additional input pin
DP[16] / EXT
TRG Input /
Output Extended Trigger output pin or additional
input pin
DP[17] / WR
RAM Input /
Output Write Ram signal used as output pin or
additional input pin
DC_TO Output Digital Connector Trigger out.
Pattern Generator Trigger Out signals are
sent to DC_TO pins on Pod A/Pod B probes.
DC_TI Input Digital Connector Trigger IN.
When DC Trigger IN Source is enabled (see
Settings →Trigger IN menu), trigger in signal
of Pod A Pattern is acquired from DC_TI pin
on Pod A, trigger in signal of Pod B Pattern is
acquired from DC_TI pin on Pod B.