Teledyne LeCroy ArbStudio - Manual (Page 139)

Operator’s Manual
922244-00 Rev A 131
B
With a new acquisition complete, the State Listing screen is not yet shown.
Instead, a Signal Selection screen is shown where you can select which
signal(s) should be displayed.

To add a signal or bus to the list on the right, select it on the left and
click the Add button.

Add all signals with one click using the Add All button.

Remove a single signal from the visualization list (on the right) by
selecting it and clicking the Remove button.

Remove all signals from the visualization list with one click using the
Remove All button.
Once you've made your selections and clicked the OK button, the State
Listing screen is then shown.