Teledyne LeCroy ArbStudio - Manual (Page 157)

Operator’s Manual
922244-00 Rev A 149
B
The DEV1 Settings Ch 1 pop-up screen is shown.
The General Tab is shown by default when the pop-up displays. On
the General Tab be sure to select an Output Impedance value
suitable for your impedance load. For example, if you need to
connect the instrument to an oscilloscope, select 50 Ω as the output
impedance load and 50 Ω as the input impedance on the
oscilloscope channel.
6. On the The DEV1 Settings Ch 1 pop-up screen's Run Mode tab,
select Single and press OK.