Teledyne LeCroy USBTracer_Trainer - Users Manual - Manual (Page 68)

Chapter 3: Installation USB Protocol Suite User Manual
54
LeCroy Corporation
To remove an expansion card, follow these steps:
Step 1 Unplug the system from AC power and turn the system so the expansion port is
facing you. Note the two retaining screws and the holes for the extraction tool that
are located on the panel of the expansion card.
Note: The example shows a different expansion card, but the removal method is
the same.
Step 2 Insert the extraction-tool prongs into the holes in the expansion card panel.
Note: If the prongs do not slip easily into the holes, use a small nail file or similar
device to remove paint from the prongs.
Step 3 Rotate the extraction tool to a horizontal position to lock the prongs into place and
make a handle.