10 using a single-state sequence, 11 using a multi-state sequences, 12 using independent sequences – Teledyne LeCroy USBTracer_Trainer - Users Manual User Manual
Page 276
Chapter 10: Recording Options
USB Protocol Suite User Manual
262
LeCroy Corporation
10.5.10 Using a Single-State Sequence
As described previously, a sequence can be single-state or multi-state. A single-state
sequence is a simple combination of events and actions. You cannot create looping or
branching conditions with this type of sequence.
A multi-state sequence allows you to branch successively to (advance to) lower states in
the sequence or to loop to the front of the sequence (restart the sequence).
10.5.11 Using a Multi-State Sequences
Multi-state sequences allow you to create conditions that branch down to successive
states or loop back to the beginning of the sequence. They are more complex than
single-state sequences but very powerful.
10.5.12 Using Independent Sequences
You can use up to two independent sequences. By default, they are labeled Sequence 0
and Sequence 1.
The two sequences operate in parallel and have no effect on each other with the following
exception. Either of the two sequences can contain the action Restart All. This action
restarts both sequences in the Main Display area.