Teledyne LeCroy USBTracer_Trainer - Users Manual User Manual
Page 215
USB Protocol Suite User Manual
Chapter 9: Reports
LeCroy Corporation
201
To Reset Navigator Range
You can reset the Navigator range using the toolbar Navigator Range button. Press the
button to bring up the Navigator Range drop-down menu.
The menu has the following options:
•
Set Range to Whole Trace: Allows you to reset the range to include the entire trace
file contents. The top range delimiter is placed at the lowest packet number in the
trace. The bottom range delimiter is placed at the highest packet number in the
trace.
•
Set Range Near Packet xxx: Allows you to collapse the range so that only the
packets immediately above and below the xxx packet are displayed. The xxx packet
is whatever packet is currently at the top in the trace display.
•
Recently Used Ranges: Allows you to reset the range to any of a number of
recently used (previously set) ranges.