Teledyne LeCroy USBTracer_Trainer - Users Manual - Manual (Page 65)

USB Protocol Suite User Manual Chapter 3: Installation
LeCroy Corporation
51
Chapter 3: Installation
The Analyzer software installs on a Microsoft ® Windows ® XP, Windows Vista™ 32,
Windows Vista 64, or Windows 7 (32 or 64) personal computer system.
Note: USBMobile T2 and USBMobile HS are not supported on 64-bit
operating systems.
Important!
Please uninstall any versions of USBTracer, USB Advisor, or USBMobile HS
software on your computer BEFORE installing USB Protocol Suite. The older
software is not compatible with the new software and device drivers. You can load
files recorded using the old software into USB Protocol Suite, which will
automatically convert them to the new format.
3.1 Installing the Analyzer Software on the PC
Note: You must install the software before connecting the Analyzer to the host
machine for the first time.
Install the software on the PC administering the Analyzer:
Step 1 Insert the Installation CD into the CD drive of the PC that administers the
Analyzer.
Step 2 Follow the on-screen installation instructions to install the application on the PC
hard disk.
3.2 Setting Up the Analyzer - USB Connection
To set up an Analyzer using a USB connection:
Step 1 Connect the AC power cord to the rear of the Analyzer and to a 100-volt to
240-volt, 50-Hz to 60-Hz, 100-W power outlet.
Note: The Analyzer is capable of supporting supply voltages between 100 volts
and 240 volts, 50 Hz or 60 Hz, thus supporting all supply voltages around the
world.
Step 2 Connect the USB port to a USB port on the PC using the LONG (6-foot/2-meter)
USB 2.0 cable.
Step 3 Insert the Installation CD.
Step 4 Turn on the power switch.
Note: At power-on, the Analyzer initializes itself in approximately ten seconds and
performs an exhaustive self-diagnostic that lasts about five seconds. If the
diagnostics fail, call LeCroy Customer Support for assistance.
Step 5 Click Next after you see the Add New Hardware Wizard window.