Teledyne LeCroy USBTracer_Trainer - Users Manual - Manual (Page 104)

Chapter 4: Software Overview USB Protocol Suite User Manual
90
LeCroy Corporation
4.8 CrossSync Control Panel
The CrossSync Control Panel allows you to select analyzers for synchronization and
manage the recording process.
4.8.1 Launching the CrossSync Control Panel
To launch CrossSync from the USB Protocol Suite software application, select the
‘Launch CrossSync Control Panel‘ entry in the ‘Setup’ menu (see the screen capture
below). Or, you can launch CrossSync from the ‘Start’ menu.
Figure 4.1 Launching CrossSync from the USB Protocol Suite
Application
For more information, refer to the CrossSync Control Panel User Manual.
Note: If you are using CrossSync, USB Compliance Suite, or any application that
uses the Automation Interface to the USB Protocol Suite, and the system
prompts you that it cannot write a trace file to disk:
1. Make sure that the trace-file destination folder has write/create
permissions. (For example, the target directory might be the netwrok file
system, which typically does not have write/create permissions.)
2. Make sure that the Windows (or other) Firewall Settings for
USB Protocol Suite are set to Public.