Teledyne LeCroy USBTracer_Trainer - Users Manual - Manual (Page 279)

USB Protocol Suite User Manual Chapter 10: Recording Options
LeCroy Corporation
265
10.6.4 Dragging a Button to the Main Display Area
After you create an Event button in the Available Events area, you can drag the button to
the Main Display area and drop it in the appropriate cell (a cell is a grayed-out rectangle
with a dashed line around it). You can think of each cell as a target for drag-and-drop of
an Event button.
There are two types of cell that might appear: Sequence cell and State cell. In the
Main Display area, they are labelled as follows:
• Sequence cell: Drag an event here to add a new sequence.
• State cell: Drag an event here to add another state. Note: Recording Rules for
USB 3.0 currently do not support more than two independent states.
If there currently are no events in the Main Display area, a single sequence cell appears
at the top of the area.
To drag-and-drop the Event button, see “Dragging a Button to the Main Display Area” on
page 252