IAI America CON-PGA - Manual (Page 129)

6. Operation of SEP
Related Controllers
121
[7] Ecology... When Ecology is enabled, you can have the motor power (servo) turned off automatically
upon elapse of a specified period to save power after completion of positioning. Set the applicable period
beforehand using a parameter.
Parameter No. Parameter name
Initial
value
Setting
range
10 Auto servo OFF delay time [sec] 1 0 ~ 9999
[Auto servo OFF]
The servo will turn off automatically upon elapse of a specified period after completion of positioning. When
the next positioning command is issued, the servo turns on automatically and positioning is performed.
Since no holding current flows while the motor is at standstill, power consumption can be reduced.
Move signal 1 (ST0)
Move signal 2 (ST1)
Actuator movement
Servo status
Auto servo OFF mode
(A green LED blinks)
T: Time set by parameter No
Start point detection (LS0)
End point detection (LS1)
Intermediate point detection (LS2)
Positioning to start point complete (PE0)
Positioning to end point complete (PE1)
Positioning to intermediate point complete
(PE2)