Micromod MOD: 1800P - MOD 30ML Identity Module (Version 2) System, I/O and Communications Functions - Manual (Page 261)

Logic Functions - Book 1
APPENDIX B - MODBUS MASTER CONFIGURATION
B-17
B.3.6 Write One or More Coils
The configuration of a Modbus Master EX block used to write one or more Coils (Discretes) in
memory area 00001 to 09999 is defined as:
INPUT1 WRC,MM,PORTz Local ASCII CFG ONLY
Not writeable through message handler.
INPUT2 NUMBER WRITE ATTRIBUTES Local Count CFG ONLY
Not writeable through message handler.
This value is the number of attribute values that should be written. The values
to be written are stored at this block’s INPUT11 through INPUTn. Valid values
are 1 through 2000.
INPUT3 STATUS INFO Local Long State
Not writeable through message handler.
See Message STATUS INFO values and descriptions above.
INPUT4 MESSAGE QUALITY Local Discrete
Not writeable through message handler.
GOOD (0) if a valid response message was received.
BAD (1) if a valid response message was not received.
INPUT5 MESSAGE ACTIVE Local Discrete
Not writeable through message handler.
Specifies whether the message transaction has been completed. The value
will be set to 1 (TRUE) when the message is triggered and remains set until
the transaction is complete or until failure is determined.
INPUT6 RESERVED Local Long State
Not writeable through message handler.
IF REFRESH STATE = 0
Previous send input value. Used in detecting low->high trip transaction.
ELSE IF REFRESH STATE = 255
This value is not used.
ELSE IF REFRESH STATE = 1 through 254
This value will get set equal to the REFRESH STATE value and decrement
by 1 each time this block executes. When it gets to 0 the read message is
sent to the slave. This value will remain at 0 until a response message is
received or the message times out. It will then repeat the cycle again.