Micromod MOD: 1800P - MOD 30ML Identity Module (Version 2) System, I/O and Communications Functions - Manual (Page 197)

Logic Functions - Book 1
REMOTE DIGITAL INPUT MODULE BLOCK (RDIM)
6-19
15 - 30 Extended Error, Channel 0 (EXTERR0) through Channel 15 (EXTERR15) – WR
The last error code as read from the remote module (whether active or not). See packed
extended errors PKDERRS attribute 126. Codes are as follows:
0 No Error
1 Internal error in remote unit
2 Cut wire (open circuit)
4 Overload + open circuit
6 Overload + open circuit
8 Short circuit
10 Short Circuit +open circuit
12 Overload + short circuit
14 Short circuit + overload + open circuit
15 Remote module not present
16 No remote I/O present
31 - 46 Mode, Channel 0 (MODE0) through Channel 15 (MODE15)..............................................CWR
The mode of the block is determined by configuring and/or writing this attribute. Switching
mode is a reportable block event.
MAN 0 The result can be user written and is not updated with the field result
value. The field result is updated with the input from the remote
module.
AUTO 1 The block input is processed using the field result data from the
remote input module.
60 Packed Results (PKDR).....................................................................................................CWR
The results of block evaluation expressed as packed bits. Each of the 16 channels is
represented by one bit but only the bits for channels in use are meaningful (see attribute 14).
The results are writeable when I/O is locked or the instrument state is not run, Results can
also be written when at least one channel is in manual; only the channels in manual are
changed in this case. The channel 0 result is the least significant bit and the results are
indicated as follows:
FALSE 0
TRUE 1
61 Packed Results Quality (PKDRQ).................................................................................... – WR
The quality bits corresponding to the packed results, attribute 60. Quality is writeable under
the same conditions as described for attribute 60. The channel 0 result quality is the least
significant bit and quality is indicated as follows:
GOOD 0
BAD 1
62, 66... 122 Field Result,Channel 0 (FR0) through Channel 15 (FR15)................................................– – R
This is the actual field input value to the remote module.
63, 67... 123 Field Result Quality Channel 0 (FR0Q) through Channel 15 (FR15Q).............................– – R
This data quality attribute is marked BAD (1) if any diagnostic error in the block becomes
active.