Micromod MOD: 1800P - MOD 30ML Identity Module (Version 2) System, I/O and Communications Functions - Manual (Page 12)

Logic Functions - Book 1
INTRODUCTION
1-2
Additional information about instrument installation can be found in:
•
IB-23C600 – Installation, MODCELL Multiloop Processor
•
IB-23C601 – Installation, Remote I/O Modules
•
IB-1800R-INS – Installation, MOD 30ML Multiloop Controller
•
IB-1800R-M30 – Installation, MOD 30ML Replacement for MOD 30
Additional MODBUS connection information can be found in the following:
•
IB-MODBUS-RTU – MODBUS™ RTU Communications Guide for use with MODCELL,
MOD 30ML and Commander Products
Additional ICN connection and loading information can be found in the following:
•
IB-23A160 – Instrument Communications Network (ICN) Planning
Users developing Instrument Communication Network (ICN) interface software to this
instrument will also need the following:
•
IB-23G001 – ICN Communication Link Programmers Manual
1.5 VERSION IDENTIFICATION
To verify the version level of the instrument, check the version number marked on the PROM
label of the identity module. The firmware version is a digit in the catalog number as follows:
Catalog Number Description for 2001P
BASE NUMBER
2001P MODCELL Logic Control Identity Module
UNUSED Z Unused Character
ELECTRICAL CODE 10 General Purpose
FUNCTION 1 Logic Control
FIRMWARE VERSION 01 Version 1
02 Version 2
03 Version 3
04 Version 4
05 Version 5
06 Version 6
MODEL A Design Level (256K PROMs)
B Design Level (512K PROMs)
C Design Level (512K Flash RAM)
Sample Number 2001PZ10106C (Product is serialized)
Version number identification for specific blocks is obtained through the database. See
Appendix A for a summary of version differences.