Micromod MOD: 1800P - MOD 30ML Identity Module (Version 2) System, I/O and Communications Functions - Manual (Page 166)

Logic Functions - Book 1
ANALOG INPUT MODULE BLOCKS (VCIM, TIM, RIM, WRIM)
5-46
VCIM 26 Field Result (FR) ............................................................................................................... – – R
TIM 24 Field Result (FR) ............................................................................................................... – – R
RIM 28 Field Result (FR) ............................................................................................................... – – R
WRIM 27 Field Result (FR) ............................................................................................................... – – R
This is the actual field input value to the instrument. A resistance input module count of
±25,000 is converted to the field result of 0 to 50,000.
VCIM 27 Field Result Quality (FRQ) ............................................................................................... – – R
TIM 25 Field Result Quality (FRQ) ............................................................................................... – – R
RIM 29 Field Result Quality (FRQ) ............................................................................................... – – R
WRIM 28 Field Result Quality (FRQ) ............................................................................................... – – R
The field result data quality will go bad if any of the blocks diagnostic errors becomes active.
5.4.7 Typical Block Connections for Analog Input Module Block
Typical softwiring block structures used on softwiring diagrams are shown in Figure 5-25.
Slot 1
Operator write access to set
mode and manual data.
Softwiring connection to
Voltage/Current Input Block (VCI).
MODE
RQ
R
VCIM1
Operator indication of
data quality and block
mode.
Result Quality
Mode
Field Result
1
2
TIM1
Field Result
RIM1
MODOUT
Slot 2
1
2
CJCIN
R Result Softwiring connection
to another block.
Result
Figure 5-25. Typical Block Connections for Analog Input Module Block
5.4.8 Analog Input Module Block Events
The event codes (and their suggested text messages) for the analog input module block types
are given below. See the referenced data base attributes (in brackets) for additional
information. See the system event block for a description of event transitions.
4 BLOCK MODE SET TO AUTO
5 BLOCK MODE SET TO MANUAL
6 I/O MISMATCH (5)
7 I/O COMMUNICATIONS ERROR (8)
8 VI MODULE ERROR (11) or
8 TI MODULE ERROR (11) or
8 RIM MODULE ERROR (11) or
8 WRIM MODULE ERROR (11)