Micromod MOD: 1800P - MOD 30ML Identity Module (Version 2) System, I/O and Communications Functions - Manual (Page 104)

Logic Functions - Book 1
MODCELL SERIAL COMMUNICATION BLOCK
4-22
4.3.2 Modcell Serial Communication Block Parameters
The mnemonics, valid values, and data types for all fields that may be selected for display
and/or be used in making softwiring connections are listed in Table 4-2. The following further
defines the MSC block configuration parameters.
Block Type
MSC
This is the Modcell Serial Communication Block type.
Occurrence
1 to 3
There may be up to three ‘instances’ allowed of the Modcell Serial communication
block.
Module location
Scrolled entry. Indicate the slot(s) that the module occupies. Make sure this is compatible with
the module type specified below. MSC modules can occupy 1 or 2 slots, and are associated
with a MODCELL port as follows:
PORT1 - slots 32, or 31-32
PORT2 - slots 29, 28-29, 30, or 29-30
PORT3 - slots 26, 25-26, 27, 26-27, 28, or 27-28
Wiring description
Keyed entry. Any text description.
02 State (STATE) .................................................................................................................... – – R
Not configurable in this block (always equal to RUN). See Section 2.4.1, State Changes for
additional information. This block, when configured, is always executed in the RUN state
(Normal Operation).
03 Bad Inputs Accepted (BADINP) ....................................................................................... – – R
This attribute is not used with this block. The MSC block always runs without a check on input
quality. See Section 2.3.2, Data Quality for additional information.
04 Diagnostic Group (SUPPGRP)......................................................................................... CWR
The diagnostic errors reported by this block can be grouped for System Event block control of
their reporting.
NONE No group assigned. Read as 0.
1 to 7 The number of the diagnostic suppression group as controlled by the
System Event block.