Micromod MOD: 1800P - MOD 30ML Identity Module (Version 2) System, I/O and Communications Functions - Manual (Page 179)

Logic Functions - Book 1
REMOTE INPUT/OUTPUT BLOCKS
6-1
6
REMOTE INPUT/OUTPUT MODULE DATA BASE PARAMETERS
6.1 REMOTE INPUT/OUTPUT LIBRARY BLOCKS
Remote Input/Output module blocks define a physical input or output connection point and are
not part of a loop scan group. The Remote I/O module blocks are available inside or outside
of loop compounds. One of these modules is required to get a remote field signal into the
instrument. Remote I/O modules are selected from the Remote Input/Output Library at the
instrument or loop level. The different types and their associated hardware modules are:
RIO Remote I/O Communication Module. Reference Section 6.2. This module
plugs into the multiloop processor board and serves as the interface between
MODCELL and a CS31 bus. The MODCELL database must have one RIO
block for each RIO module on the MODCELL board. The RIO module uses
CS31 bus address 0.
A connection is required from MODOUT of this block to MODIN of each
remote I/O block in the database that uses this block as the interface to a
CS31 bus. For each of the following, indicate that a particular channel is
used by marking the check box to the left of the channel number. Enter the
bus address of the remote CS31 module providing the inputs or outputs.
RDIM Remote Digital Input Module. Reference Section 6.3. This block represents
one or more digital input channels at an address (1-31) on a CS31 remote I/O
bus. Connect MODOUT of the RIO block to MODIN of this block. Modules
with remote digital inputs are:
ICSI 08 D1 (8 non-isolated 24Vdc input channels)
ICSI 08 E1 (8 isolated 24Vdc input channels)
ICSI 08 E3 (8 isolated 120Vac input channels)
ICSI 16 D1 (16 non-isolated 24Vdc input channels)
ICSI 16 E1 (16 isolated 24Vdc input channels)
ICSK 20 F1 (12 non-isolated 24VDC input channels)
ICSC 08 L1 (8 channels for 24VDC input)
RDOM Remote Digital Output Module. Reference Section 6.4. This block
represents one or more digital output channels at an address (1-31) on a
CS31 remote I/O bus. Connect MODOUT of the RIO block to MODIN of this
block. Modules with remote digital outputs are:
ICSO 08 R1 (8 relay output channels 2A)
ICSO 08 Y1 (8 transistor output channels 24Vdc 2A)
ICSK 20 F1 (8 isolated relay output channels)
ICSC 08 L1 (8 channels for 24VDC 500mA transistor output)