Micromod MOD: 1800P - MOD 30ML Identity Module (Version 2) System, I/O and Communications Functions - Manual (Page 223)

Logic Functions - Book 1
ANALOG INPUT BLOCKS (VCI, TII, TI, RI, RTI, RTTI)
7-13
7.2.4 Resistance Input Block Description (RI)
This block is used to input a resistance module’s value and translate it to a user specified
scaled value. It receives its input from a RIM or WRIM block only. A functional block diagram
of a resistance input block is shown in Figure 7-10. The menus used to configure the block
are shown in Figures 7-11 and 7-12.
The mnemonics, valid values, and data types for all
fields that may be selected for display and/or be used in making softwiring connections are
listed in Table 7-4. Section 7.2.8 further defines the input block configuration parameters.
BAD GOOD
Signal Range - Top
Signal Range - Bottom
Input Module
Floating Point Count
Action
(DIR/REV)
Bad Inputs
Accepted
(YES/NO)
Result Quality
Filter Time
(minutes)
Input Module No.
Output Range
Bottom
State
(RUN, HOLD,
OFF, DEBUG)
Filter Type
NONE
AUTO
USER
Filter
Quality and
Error Check
Input Module Result Quality
Result
Quality Limit
- Bottom Quality Limit
- Top
Range Check
Output Scaling
Output Range
Top
Normalization
Diagnostic
Group
(NONE, 1-7)
CERRU
CERRA
Set Quality
Bad on
Calculation
Error (Y/N)
Calculation
Error
(ENAB/SUPP)
CERRUQ
CERRAQ
Figure 7-10. Resistance Input Block (RI), Functional Block Diagram