Micromod MOD: 1800P - MOD 30ML Identity Module (Version 2) System, I/O and Communications Functions - Manual (Page 214)

Logic Functions - Book 1
ANALOG INPUT BLOCKS (VCI, TII, TI, RI, RTI, RTTI)
7-4
7.2.1 Voltage/Current Input Block Description (VCI)
This block is used to input a volt/current module’s value and translate it to a user specified
scaled value. It receives its input from a VCIM or RAIM block. A functional block diagram of a
voltage/current input block is shown in Figure 7-1. The menus used to configure the block are
shown in Figures 7-2 and 7-3.
The mnemonics, valid values, and data types for all fields that
may be selected for display and/or be used in making softwiring connections are listed in
Table 7-1. Section 7.2.8 further defines the input block configuration parameters.
BAD GOOD
Signal Range - Top
Signal Range - Bottom
Module Type
MOD SQRT
Input Module
Floating Point Count
Action
(DIR/REV)
Bad Inputs
Accepted
(YES/NO)
LINEAR
SQUARE
Result Quality
Filter Time
(minutes)
Input Module No.
Output Range
Bottom
State
(RUN, HOLD,
OFF, DEBUG)
Filter Type
NONE
AUTO
USER
Linearization Type Filter
Quality and
Error Check
Input Module Result Quality
Result
Quality Limit
- Bottom Quality Limit
- Top
Range Check
Output Scaling
Output Range
Top
Normalization
MOD SQ
SQUARE ROOT
Diagnostic
Group
(NONE, 1-7)
CERRU
CERRA
Set Quality
Bad on
Calculation
Error (Y/N)
Calculation
Error
(ENAB/SUPP)
CERRUQ
CERRAQ
Figure 7-1. Voltage/Current Input Block (VCI), Functional Block Diagram