ABUS FU9001 Privest Wireless Alarm Base Set Installation - Manual (Page 90)

10-90
• Confirm the menu option phone number 1 with the Enter button.
• On the system keypad, enter the number with local area code and if necessary a zero for obtaining a dial tone. To
program a dial pause, enter A. You program the A with the button. Press this button repeatedly until an A
appears.
• To change the entered number, press the cursor buttons and to position the cursor under the
number you want to change.
• To delete the entire number, program an E with the button at the first digit of the number and then save the
entered number with the button. The number is deleted and does not appear again when this menu option is
displayed.
• After successfully entering the number, press
to store the number. Enable the function Remote program
and Remote listen to operate your system by telephone and listen in to the object over the loudspeaker.
Press to change the settings to Y and confirm your input with . Press several times to exit
the user menu.
10.7 Triggering a test alarm
Activate your system with the remote control or press the activate button on your system. Following expiry of the exit delay
time (30 seconds), your system is active and monitoring all detectors. Now open the contact detector.
The entry delay time (30 seconds) starts. The system signals this by means of signal tones at one-second intervals.
To deactivate the system, enter the Grand Master PIN
11 22 33 44
, followed by the deactivate button (open padlock).
Close the door and reactivate your system. Wait until the exit delay time expires and then open the contact detector again.
Do not deactivate your system, but wait until the entry delay time expires. After the end of the delay time, an alarm is triggered.
After a short time, you receive a call from to the programmed telephone number. Now deactivate your system and confirm the
call on your telephone. For more information, see the brief guide on telephone control.
10.8 Changing the Grand Master PIN
Now that your system is operational, change the Grand Master PIN.
• First press the star button followed by 5.
55
• You are asked to enter the Grand Master PIN code for the user menu. The default setting is 1234. Enter this Grand Master
PIN and confirm your input with the lozenge button.
11 22 33 44
You are now in the FM user menu and see the following display:
• Press the Enter button three times
and enter the new four-digit Grand Master (SUPER) PIN on the
keypad.
• Confirm your input by pressing .
If you forget your Grand Master PIN, you can change it in the installer menu.
• Press several times to exit the user menu.