ABUS FU9001 Privest Wireless Alarm Base Set Installation - Manual (Page 73)

7-73
7. Confirm the Write menu option with
and your alarm system waits for a signal from your sounder. Send
a message from the sounder.
8. Insert all batteries in the sounder. Press the Reset key for five seconds. Then press the lid contact of the
sounder and keep it pressed until the system receives the signal. You see the following on the display:
9. Press
or to select whether the sounder is to be monitored or not, and confirm your selection
with .
The sounder is now ready for operation.
10. The following menu has four menu options:
• Skip:
Select another sounder.
• (Re) Write: Train another sounder instead of the already sounder.
• Delete: Delete a sounder.
• Supervision: Change the setting for monitoring the sounder.
7.9.2
99 22
Parameter
Under this menu option, you can change the sounder settings. You can change the following settings:
• Volume
• Flash frequency (external sounders only)
To access the Parameter menu:
1. Select the Siren menu.
2. Under Sirene, press 22
to access the
Parameter menu option. You see the following on the display:
3. Press to select the sounder whose settings you want to change and confirm with . You can now
choose between the settings for the volume and the flash frequency (external sounders only).
4. Select Volume and confirm with
. You see the following on the display:
5. You can now set the volume for the following signals:
• Entry/exit signal
• Alarm signal
• Acknowledgement signal
6. Confirm with and enter the new volume on the keypad of the system. The setting means:
• 0: Off
• 1: Quiet
• 9: Loud
Enter the volume for the other signals in the same way. You can then set the flash frequency for the external sounder.
Press to exit the menu option.