ABUS FU9001 Privest Wireless Alarm Base Set Installation - Manual (Page 76)

7-76
7.10 00 Exit Programming
Under Exit Programming, all your settings in the installer menu are saved and you exit the installer menu.
Important: The settings you make in the installer menu are not saved until you exit the installer menu correctly.
NOTES:
To be able to exit the installer menu, the J9 jumper plug must be plugged on to one pin.
To access the Exit Programming menu:
1. In the installer menu, press 00 or press or until you find the [0] Exit Programming menu
option. You see the following on the display:
This is the last option in the installer menu.
Press . You see the following on the display:
2. Save or discard all your settings/changes:
Save your changes by pressing . You see the following on the display:
The ABUS wireless alarm system returns to the normal user display.
OR:
Discard your changes by pressing to change the [Y] YES to a [N] NO on the display and then
press . The ABUS wireless alarm system returns to the normal user display.