ABUS FU9001 Privest Wireless Alarm Base Set Installation - Manual (Page 33)

7-33
System Label:
Quick-Key Menu option Default Selection
11 55 22
to
11 55 44
Partitions 1 – 3 Partitions 1–3 Any 12
characters
Changes the display for partitions 1 to 3.
Example: The example below shows how to change the name of partition 1 to “Buero”
To assign the label “Buero” to partition 1:
1. Press
22
for partition 1.
2. Press
11
three times until the letter B appears on the display and then press
once to move the cursor to the right.
3. Press
55
repeatedly until the letter u appears on the display and then press
again to move the cursor forwards.
4. Press
44
repeatedly until the letter e appears on the display and then press
to move the cursor forwards.
5. Press
55
repeatedly until the letter r appears on the display and then press
again to move the cursor forwards.
6. Press
55
repeatedly until the letter o appears on the display and then press
again to move the cursor forwards.
7. Press
66
twice for a space and then press to move the cursor forwards.
In this way, delete the unwanted characters.
7.2.6
11 66
Tamper Sound
In the Tamper Sound menu, you can define the sounds generated by the ABUS wireless alarm system following a tamper in a zone,
the ABUS wireless alarm centre housing, the wireless operating panel, or any other device. You can also adjust the sounder volume for
alarms and their acknowledgement.
To access the Tamper Sound menu:
1. Select the System menu as described on page 7-24.
2. In the System menu, press
66
to access the menu option of the Tamper Sound menu. You see the
following on the display:
3. Select and configure the settings in the Tamper Sound menu as follows:
Tamper Sound:
Quick-Key Parameter Default Range
11 66 11 Tamper sound Bell/A Buzzer/D 1 to 5
Programs the signals generated by a tamper alarm.
Setting Sound
1 Silent
2 Bell only (external sounder)
3 Buzzer only (piezo on operating panel)
4 Bell and buzzer
5 Bell/Arm, Buzzer/Disarm
NOTE:
If you set sounder/active and buzzer/inactive, the system will activate only the buzzer when
in deactivated state. If the system is active, the external sounder is also activated.