ABUS FU9001 Privest Wireless Alarm Base Set Installation - Manual (Page 48)

7-48
7.4 33 Outputs
Under Outputs, you program the relay and transistor outputs of the system. You link different system events to the activation of the
outputs. The following is an overview of the menu options according to their sequence in the Outputs menu:
33 11
Define, page 7-48
33 22
Output A, page 7-53
33 33
Output B, page 7-53
To access the Outputs menu:
In the installer menu, press
33
or press or until you find the number of the Utility Output [3]
menu option. Press . The first submenu appears on the display:
You are now in the
Outputs menu and can access the submenus as described in the following sections.
7.4.1 33
11
Define
Under Define, you can program specific outputs.
To access the Define menu:
1. Select the Outputs menu as described on page 54.
2. Under Outputs, press 11 to access the Define menu option.
3. Enter a two-digit number for the output you want to program. Enter a zero (0) and a number from 1 to 9 (for
example: 01, 02 etc.). Then press . You see the following on the display:
4. You can now program the selected switch output. After defining the event to be followed by the output,
press and continue with the displayed menus to program the areas (only for outputs that follow an
area; see page 7-52).
Define
Quick-Key Parameter
33
11
UO UO 00 Follow nothing
The switch output follows no event and is therefore deactivated.
33
11
UO UO 11
Follow system
This menu option shows system events.
33
11
UO UO 11
01
01
Bell Follow
This switch output is activated if an external sounder is activated. In the case of a
sounder delay, this output is activated following the expiry of the delay period.
33
11
UO UO 11
02
02
No Telephone Line
The switch output is activated if a break in the telephone line is detected. It is deactivated
after the telephone line fault is removed.
33
11
UO UO 11 03 03
Communication Failure
The switch output is activated if no contact to the command centre can be established. It is
deactivated after a successful call is made to the command centre.