ABUS FU9001 Privest Wireless Alarm Base Set Installation - Manual (Page 56)

7-56
7.5.2
44 22
Partition
Default: Partition 1
Under Partition, you assign to user PINs partitions for which you have authority. The Grand Master is authorised in all partitions.
To access the Partition menu:
1. Select the Codes menu as described on page 7-53.
2. Under Codes, press
22
to access the Partition menu option.
3. Enter the respective two-digit user code and press . You see the following on the display:
4. Press or to place the cursor under the number specifying the partition to which you want to
allocate the code.
5. Change the authority of the user for the respective partition with buttons 1 to 3.
An area authorised for the used is shown with a “Y” under the partition number (1 to 3).
NOTE:
A standard system uses only Partition 1.
6. Press to program a different user code.
7. Repeat steps 2 to 6 until all user PINs created in the system are allocated to partitions.
8. To exit the menu option, press .
7.5.3
44 33
Grand Master
Default: 1234
Under Grand Master, you can change the Grand Master PIN.
NOTE:
The Grand Master (only) can also change the code in the user menu.
The Grand Master has most rights. For further information about the rights and options of other users, see under
“Authority Levels” on page 7-54.
To access the Grand Master menu:
1. Select the Code Maintenance menu as described on page 7-53.
2. Under Code Maintenance, press
33
to access the Grand Master menu option. You see the following on
the display:
3. Enter the new Grand Master PIN on the system keypad and then press
4. Press to exit the menu option.
NOTE:
The Grand Master, the installer and the sub-installer can enter and change PIN codes of other authorities.