ABUS FU9001 Privest Wireless Alarm Base Set Installation - Manual (Page 54)

7-54
7.5
44
Codes
Under Codes, you can define user and installer Codes, define authorities, and assign areas.
The ABUS wireless alarm system also has the following Codes.
Grand Master Code: Used by the system owner. This Code has authority over all others and can only be changed but not
deleted. The default is: [1][2][3][4].
Installer Code: This Code is needed for programming the system. The default is: [0][1][3][3].
Sub-Installer Code: This Code can also be used for programming the system. However, the options are restricted.
Program the codes as follows:
• Define the authority level of each user code.
• Allocate the areas to a specific code.
• Change the Grand Master Code, the Installer Code and the Sub-Installer Code
• Optionally, you can first extend the security level of a six-digit Code.
The following is an overview of the menu options according to their sequence in the Codes menu:
44 11
Authority, page 7-54
44 22
Partition, page 7-55
44 33
Grand Master, page 7-56
44 44
Installer, page 7-57
44 55
Sub-Installer, page 7-57
44 66
Code Length, page 7-57
To access the Codes menu:
In the installer menu, press
44
or press or until you find the number of the Code [4] menu option. Press
. The first submenu appears on the display:
You are now in the Codes menu and can access the submenus, as described in the following sections.
7.5.1
44 11
Authority
Default: User
Under Authority, you can assign an authority to each user PIN. There are 7 authority levels that can be used for customising the
requirements of different users.
To access the Authority menu:
1. Select the Codes menu as described on page 7-53.
2. Under Codes, press
11
to access the Authority menu option. You see the following on the display:
3. Press or to select a user and press or enter the two-digit number of the user (from
01 to 31).
4. Press to switch between the authorities.
5. Press to confirm and continue with the next PIN code.
6. Press to exit the menu option.