ABUS FU9001 Privest Wireless Alarm Base Set Installation User Manual
Page 55
7-55
Authority Levels
The Authority Levels menu option contains settings for the following authorities:
Grand Master: There is only one Grand Master in the system. The Grand Master can carry out all available user functions. The
Grand Master code is defined as PIN code user 00.
NOTE:
Under System Control, you can define that the Grand Master can change authorities as well as areas permitted for users.
See under Grand Master Authority/Partition (press [1] [2] [27]).
Manager:
There is only one Manager in the system. The Manager is defined as Code user 01. The Manager can change all
user codes except that of the Grand Master. The Manager has access to all functions listed below, with the
following restrictions:
• Changing the Grand Master code
• Performing the walk test
Master:
There is no restriction on the number of Masters (as long as they do not exceed the number of codes remaining
in the system). The Master has access to all Manager privileges with the following restrictions:
• The Master is restricted to defining and changing user codes at the level of Master or below (user, arm
only, maid).
• The Master has restricted access to defined areas.
User:
There is no restriction on the number of User PIN codes (as long as they do not exceed the number of PIN codes
remaining in the system). A user can:
• Activate/deactivate
• Omit
zones
• Access defined areas
• View the state of the system, faults and the alarm memory
• Activate
defined
switch
outputs
• Change his/her own user PIN
• Conduct selected system tests but no walk tests
Arm Only:
There is no restriction on the number of Arm Only PIN codes (as long as they do not exceed the number of PIN
codes remaining in the system). Users with Arm Only PIN codes only have the authority to activate one or more
areas.
Maid:
A PIN code with the Maid authority is a temporary user PIN that is deleted by the system immediately after being
used for an activation. User PINs with this authority are used as follows:
• For a once-only activation in one or more areas
• The user PIN can be used the first time to deactivate the system and then to activate it.
UO Only:
A PIN code with the UO Only authority is used to activate/deactivate a switch output manually.
User Unbypass:
A PIN code with the User Unbypass authority has access to all user authorities except omitting zones.