ABUS FU9001 Privest Wireless Alarm Base Set Installation - Manual (Page 43)

7-43
Zone sound
Quick-Key Parameters Default Range
22 22 55 ZZ ZZ
+
11
Silent
No audible alarm is generated. An alarm is transmitted by telephone only.
22 22 55 ZZ ZZ
+
22
Bell Only
Activates the external and internal sounders for the defined sounder duration or until a
valid user code is entered and the key is pressed.
22 22 55 ZZ ZZ
+
33
Buzzer Only
Activates the piezo buzzer of the alarm system.
22 22 55 ZZ ZZ
+
44
Bell + Buzzer Default for all
zones
Activates the piezo buzzer plus the internal and external sounders. The sounders
switch off when the programmed sounder duration expires.
22 22 55 ZZ ZZ
+
55
Door Chime
If the system is inactive, this causes the piezo buzzer of the alarm system to emit 3 short
beeps. If the system is active, the internal and external sounders are activated.
22 22 55 ZZ ZZ
+
66
(Bell/A Buzzer/D)
If the system is inactive, this activates the piezo buzzer of the alarm system, and if the
system is active, the internal and external sounders are activated.
22 22 66 Force Arm
The Force Arm setting for a zone enables the system to be activated even if one
or more zones are open, provided these zones were programmed with this setting.
• If such a zone is open, the “ready” system LED flashes.
• After the system is activated, all open zones programmed as Force Arm are
automatically excluded from monitoring.
• If such a zone is closed in active status, it is returned to monitoring.
To program a zone with the Force Arm setting:
1. Under Parameters, press
66
to access the Force Arm menu option. You see the
following on the display:
2. Enter the zone number for which you want to program for Forced Arming and press
.
3. Press or to select Enable or Disable and then press .
Repeat steps 1 to 3 to program this settings for the other zones.
Press to exit the menu option.