ABUS FU9001 Privest Wireless Alarm Base Set Installation - Manual (Page 74)

7-74
7.9.3
99 33
Communication test
Under communication test you test the radio communication between your sounder and the system.
To access the communication test menu:
1. Select the Siren menu as described above.
2. Under Siren, press
33
to access the communication test menu option. You see the following on the
display:
3. Confirm with . The system now searches for the wireless sounders and then shows the signal
strength of each sounder on the display.
NOTE:
For successful transmission, the signal strength should be higher than the value of the receiver defined under
“Calibration” (see below).
Press to exit the menu option.
7.9.4
99 44
Siren Receiver Calibration
Under siren receiver calibration, you can adjust the reception quality of the sounders. Since this communication is based on a
different wireless technology, a different value is possible here than when you calibrate the receiver for the wireless transmitter.
The level is between 0 and 99. The lower the value, the better the radio communication between the system and the sounder.
To access the sounder receiver calibration menu:
1. Select the Siren menu as described above.
2. Under Siren, press
44
to access the siren receiver calibration menu option. You see the following on the
display:
3. Confirm with . The system now recalibrates the radio threshold.
4. Confirm the new threshold with .
5. To make a new calibration, press to change to Y and confirm with .
Press to exit the menu option.