ABUS FU9001 Privest Wireless Alarm Base Set Installation - Manual (Page 42)

7-42
Parameter
Quick-Key Parameter Default Range
22 22 44 ZZ ZZ
+
18 18
Exit Termination
A zone with the Exit Termination zone type behaves like a zone with the Exit(OP)/Entry
zone type. However, the difference is that an exit delay time is ended immediately if this
zone is opened or closed during the exit delay time.
When you enter the protected area, the entry delay time of Group 1 starts as usual.
22 22 44 ZZ ZZ
+
19 19
Latch Keyswitch
A zone with the Latch Keyswitch zone type is used for activating/deactivating one or more
areas. The area remains active as long as the zone is open, and is deactivated as soon as
the zone is closed.
22 22 44 ZZ ZZ
+
20 20
Entry Follower + Stay
(Internal)
If armed, this zone works like a zone type Entry Follower. If stay armed this zone type
works like an exit/entry zone of Group 1.
22 22 44 ZZ ZZ
+
21 21
Keyswitch Delay
A zone with the Keyswitch Delay zone type is used for activating/deactivating one
or more areas. This zone type is comparable to zone type Key switch, except that
the area is first activated following expiry of the entry/exit delay time of Group 1.
22 22 44 ZZ ZZ
+
22 22
Latch KSW Delay
A zone with the Latch KSW Delay zone type is used for activating/deactivating one
or more areas. The area remains active as long as the zone is open, and is
deactivated as soon as the zone is closed. This zone type is comparable to zone
type Blockschloss, except that the area is first activated following expiry of the
entry/exit delay time of Group 1.
22 22 55 Zone Sound
Under Zone sound, you can, for each zone, define the alarm signal individually
that is triggered when the alarm system is active.
1. Under Parameters, press
55
to access the Zone sound menu option. You see
the following on the display:
2. Enter a two-digit number and press .
3. Select and configure a zone signal for each zone.