ABUS FU9001 Privest Wireless Alarm Base Set Installation - Manual (Page 87)

10-87
10.2 Training the detectors for the ABUS wireless alarm system
10.2.1 Installer menu of the ABUS wireless alarm system
• First press the star button, followed by 9, followed by 1.
99 11
• You are asked to enter the installer PIN code for the installer menu. The default setting is 0133. Enter this installer
PIN and confirm your input with the lozenge button.
00 11 33 33
You are now in the installer menu and see the following display:
10.2.2 Allocate detectors
• Press
22
.
You are in the Zones menu option.
• Press
11
followed by
01 01
followed by followed by
22
. Press .
The system waits for a signal from the detector.
• Press the spring of the wireless opening detector and keep it pressed until the system receives the message from the detector
(normally within 15 seconds).
The system acknowledges that it has received the signals with a beep.
If not, repeat the procedure.
If the repeated attempt is unsuccessful, you are outside the radio transmission range. Reduce the distance between the
system and the detector until the learning process is successful.
• Now
press to complete the leaning process for this detector.
The system acknowledges this with a long beep.
• To train the next detector, press followed by
22
. Press .
The system waits for a signal from the next detector.
• Press the lid contact of the wireless motion sensor and keep it pressed until the system receives the message from the
detector (normally within 15 seconds).
The system acknowledges that it has received the signals with a beep.
If not, repeat the procedure.
If the repeated attempt is unsuccessful, you are outside the radio transmission range. Reduce the distance between the
system and the detector until the learning process is successful.
• Now press to complete the leaning process for this detector.
The system acknowledges this with a long beep.
• To train the next detector, press
followed by
22
. Press .
The system waits for a signal from the next detector.
• Insert the two batteries in the wireless smoke detector and wait until the system receives the learn message from the detector
(normally within 15 seconds).
The system acknowledges that it has received the signals with a beep.
If it does not, remove the batteries and wait 30 seconds. The repeat the procedure.
If the repeated attempt is unsuccessful, you are outside the radio transmission range. Reduce the distance between the
system and the detector until the learning process is successful.
• Now press to complete the leaning process for this detector.
The system acknowledges this with a long beep.
• Press twice to complete the learning process. You see the following in the display: