ACU-RITE MILLPWR 2 Axes - Manual (Page 211)

REMOTE STORAGE
MILLPWR ®
Setting up a COM Port and BAUD Rates
After the Remote Storage software has been installed on a PC, the following screen will
appear:
Now you need to identify a COM (short for “communication”) port and set the BAUD
rate.
• COM Port - COM port 1 is the program's default setting. You can switch to
COM port 2 by pressing the F1 key on the PC's keyboard. Remember that the
COM port setting must be available, and it must correspond with the PC port that
you connected the serial cable to.
• BAUD Rate - Set the BAUD rate by pressing the F2 key on your PC's keyboard
and scrolling through the list of BAUD rates available until the correct value
appears. Check that the BAUD rate you define for your PC matches the BAUD
rate you set for
MILLPWR .
After the COM port and BAUD rate have been set, you can begin storing part programs
onto your PC using
MILLPWR 's serial port. (For more information about creating, saving,
and deleting programs, refer to Programming.)
Operation Manual 8-4