ACU-RITE MILLPWR 2 Axes - Manual (Page 143)

PROGRAM STEPS
MILLPWR ®
Operation Manual 5-54
Comment Step
With MILLPWR , you have the ability to insert messages
anywhere within a program. These messages can be
displayed during machining (at run-time) or as Operator
Intervention Messages (OIM). These messages become
operational steps within the program and communicate
pertinent information—like "ROTATE PART" or
"ACTIVATE COOLANT".
For comments that don't require an operator intervention,
select "No" when asked if you want the comment displayed at run-time, and
MILLPWR
will skip over them during machining. (You can always retrieve the message by
highlighting the comment step in the program steps list and pressing
ENTER .)
To program a comment step:
• From the PGM screen, press the MORE STEPS
softkey.
• Press the MORE STEPS softkey two more times.
• Press the COMMENT softkey.
• Enter a message. You may include up to 20
characters, mixing numbers, letters, spaces and
symbols if you wish.
To add a space, highlight a blank spot within the
alphabet box and press the
ENTER key.
To add numbers, math symbols (+, -, x, ÷) or a
decimal point, use the keypad on the operator console.
• Press the ALPHABET softkey again when you have finished entering a message, and
the alphabet box will disappear.
• Highlight “Display At Run-time”. Press the YES softkey to display the message
during machining or the NO softkey if you don't want the message displayed.
• Press the USE key.