Program steps – ACU-RITE MILLPWR 2 Axes User Manual
Page 124

PROGRAM STEPS
MILLPWR
®
Operation Manual
5-35
Repeat
Using this step you can repeat whole programs or sections of programs horizontally,
vertically or both.
To program a repeat:
•
From the PGM screen, press the
MORE STEPS
softkey.
•
Press the
REPEAT
softkey.
•
Enter the number of the first step and the last step
in the step range that you want to repeat.
Tip:
Use the
TEACH POSITION
softkey to indicate
the X and Y offsets.
•
Enter the offset along the X- and/or Y-axes.
(The offset is the distance between repeats.)
•
Enter how many times you want to repeat the
original shape.
Note:
The steps being repeated must precede the
“Repeat” step.
Note:
Entering a 0 (zero) for the number of repeats will change the location of the
original steps entered in the FROM and TO fields. To shift the datum of an
entire program, place a repeat step at the end of the program and enter the
required coordinate shift(s) in the X-, Y-, and/or Z-axis fields. When USE is
pressed the entire program will shift by the entered values.