Xerox 4635 - Manual (Page 99)

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS1324 Energy Saver mode is disabled
The energy saver has been turned off.
Action None.
OS1325 IOT Attention steady light is xxx, flashing light is xxx
After entering the ATTENTION LIGHT command, this message
tells you whether the attention light(s) on your system‘s printer is
enabled or disabled, steady or flashing. If you enter the
ATTENTION LIGHT command with no new parameters, the
message provides the current settings.
Action None.
OS1326 Already in lockout mode
During service activities, the LOCKOUT mode has already been
initiated.
Action None.
OS1329 BINFULL criteria: n% ream threshold, n% boundary
After entering the BINFULL command with threshold and
boundary parameters, this message tells you that the values you
have entered are accepted. If you enter the BINFULL command
with no parameters, the message tells you the current settings.
Action None.
OS1330 XPS Accounting reset
XPS deletes all accounting files and recreates and initializes the
accounting recovery file.
Action Enter XPS command.
OS1331 XPS Accounting aborted
XPS has stopped accumulating accounting data because there is a
disk access error.
Action None.
OS1332 XPS Accounting resumed
XPS resumes the accumulation of accounting data because the
problem causing the abort is resolved.
Action None.
OS1333 XPS Accounting stopped: maximum file count exceeded
XPS has stopped accumulating accounting data because the
number of files has reached the maximum specified by ACFILES
in HIP.LIB.
Action None.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE 6-23