Xerox 4635 - Manual (Page 34)

HIP (HOST INTERFACE PROCESSOR) MESSAGES
HP2330 Invalid command with no host specified
A host must be selected before the command can be carried
out.
Action 1. Select a host. (Refer to your 4635 LPS Operations Reference
chapter on HIP-accessed communicating modes for
additional information.)
2. Reenter the command.
HP2340 Cannot change: HIP must be in ‘STOP’ state.
To invoke the CHANGE command, HIP must be in the STOP
state and the file must be completely received and in the
PENDING state.
Action None.
HP2341 Cannot change: job must be in ‘PENDING’ state.
To invoke the CHANGE command, HIP must be in the STOP
state and the file must be completely received and in the
PENDING state.
Action None.
HP2342 Cannot change: change process already active.
Only one CHANGE command can be invoked at one time.
Action Allow the current change process to complete before invoking
another.
HP2343 Cannot change: invalid file specification .
The output file-type is either invalid or not a type specified in the
ACCEPT list.
Action None.
HP2344 Cannot change: job does not exist.
The jid specified does not exist in the HIP job queue.
Action None.
HP2345 Cannot change: output file already exists
The file specified is already resident on the disk.
Action Rename the output file and retry the CHANGE command.
4-12 XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE