Xerox 4635 - Manual (Page 30)

HIP (HOST INTERFACE PROCESSOR) MESSAGES
HP1320 Function is not supported by current host
The requested function cannot be carried out by the current
host.
Action None.
HP1325 Command not permitted by current host
You are currently logged on to the system at a level less than 2.
The command you attempted to enter cannot be accepted at
your present level.
Action 1. Log off and then log on at level 2.
2. Refer to the appropriate 4635 LPS Operator Guide.
HP1330 Buffersize=xxx, utilization=yy% zzzz blocks used, uuuu
blocks available.
This messsage provides the number of blocks available and the
amount of the buffer already used.
Action None.
HP1340 Known and current hip hosts:
This message lists the available and currently-used HIP hosts for
your system.
Action None.
HP1410 End of HIP diagnostic
The HIP command was entered during an interactive diagnostic
test, or the system failed Test 2 or 3. The diagnostic test has
been terminated.
Action None.
HP1420 End of test 3 analysis
The system failed Diagnostic Test 3. HIP has completed analysis
of Test 3 results and has identified the data line that has failed.
This message follows message HP9431 or HP9432.
Action None.
HP2010 No host selected
A host has not been selected for HIP.
Action Enter the appropriate HIPHOST command. (Refer to your 4635
LPS Operations Reference chapter on HIP-accessed
communicating modes for additional information.)
HP2020 Selected host not present on system
The host selected is not available on your system.
Action Contact your systems specialist or Xerox representative.
4-8 XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE