Xerox 4635 User Manual
Page 120
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS2030
Tape at EOV; ‘CONTINUE I’ will rewind tape.
The system has encountered the End of Volume label on the
input tape. (Because JSL contains the EOV = PAUSE statement,
the tape does not automatically rewind.)
Action
Enter the CONTINUE I command to rewind the tape.
OS2035
Input stopped. Enter ‘CONTINUE I’ when host is ready.
This message appears after a system rollover due to software
failure. It follows a message telling how far to back up the host.
or
OS2035
Input stopped. Select ‘CONTINUE I’ when host is ready.
The host has discontinued transmission. Automatic job recovery
has been initiated.
Action
1. Ensure that the current job is backed up the required number
of pages so no data is lost. (Refer to the online and offline
chapters in your 4635 LPS Operator Guide.)
2. Enter the CONTINUE I command to resume input.
OS2042
Check paper supply in Tray 3
Feeder tray 3 is out of paper or lowered.
Action
Check the feeder tray and add paper if necessary.
OS2043
Check paper supply in Tray 4
Feeder tray 4 is out of paper or lowered.
Action
Check the feeder tray and add paper if necessary.
OS2050
All appropriate trays are empty
There are no ready feeder trays in the feed source specified by
the data stream or the current FEED command.
Action
Refill one or more feeder trays and press the
resume printing.
OS2055
Establishing communications with IOT.
The OUTPUT task is establishing communication with the printer.
Until communications are established, printer status information
is not available.
Action
None.
OS2056
Finished establishing communications with IOT.
The OUTPUT task has established communication with the
printer.
Action
None.
6-44
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE