Xerox 4635 - Manual (Page 172)

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS7110- xxxx file not found messages.
A file of the type indicated in the message was called for by JDE
or DJDE, but does not exist on the system disk. (The name of
the file is displayed in the previous message.) The job will abort.
Action 1. Load the desired file onto the system disk. If its name is
listed in the file directory, reload and replace it. (Refer to
your 4635 LPS Operations Reference chapter on managing
LPS resources for additional information.)
2. Restart the job.
OS7110 CME file not found.
OS7120 PDE file not found.
OS7130 Font File not found.
OS7140 Form File not found.
OS7150 Form Font not found.
OS7160 Unable to read stockset file from disk.
An unspecified error occurred while attempting to read a
STOCKSET file.
Action Contact your systems specialist or Xerox Customer Support.
OS7170 Translation file content is improper.
When the system was sysgened for a language other than
English, the translation file which interprets commands proved to
be defective.
Action Contact your systems specialist or Xerox Customer Support.
OS7190 Problem with file=====> xxxx.
This message precedes messages OS7110 - OS7150. It indicates
which file the system was unable to locate on disk. The job will
abort.
Action See the recommended action for messages OS7110-OS7150.
OS7210 Input cannot recover —not enough dynamic memory.
Automatic job recovery has been attempted after a software
failure caused a system rollover. The system is unable to recover
data because insufficient dynamic memory remains for the
recovery program. The job is aborted.
Action 1. Restart the job.
2. If the message reappears, contact your systems specialist or
Xerox representative to obtain additional memory capacity.
OS7220 Input unable to initiate recovery.
A software failure has caused a system rollover. The system
cannot begin automatic job recovery because there is not
enough dynamic memory for it. The job is aborted.
Action 1. Restart the job.
2. If the message reappears, contact your systems specialist or
Xerox representative to obtain additional memory capacity.
6-96 XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE