Xerox 4635 - Manual (Page 62)

IFU (INTERPRESS FONT UTILITY) MESSAGES
IF4122 Character is missing at least one extent.
The FIS master lacks sufficient information to complete the ADD
process for this character.
Action 1. Correct the FIS master.
2. Reenter the ADD command.
IF4123 Substitute character bitmap is bad or missing.
During processing of the FIS master, the substitute character's
raster bitmap was found to be either missing or defective.
Action None.
IF4124 Rendered subcharacter is bad or missing.
One or more subcharacter component(s) of a rendered character
is either defective or not in the FIS master.
Action 1. Correct the FIS master.
2. Reenter the ADD command.
IF7000 ** - WRITE LOCK PROTECTION ERROR - **
A write operation could not be completed successfully, probably
because the write ring is not present on the magnetic tape.
Action 1. Put a write enable ring on the magnetic tape. (Refer to your
4635 LPS Operator Guide.)
2. Retry the command.
IF7100 Can‘t find IFUFSN.SYS; resysgen and retry ADD
The IFUFSN.SYS file, which contains default font information, was
not found on the system disk. (Refer to your 4635 LPS System
Generation Guide.)
Action 1. If authorized to do so, resysgen.
2. Retry the ADD command.
IF7101 Font file x will not open
The requested font file is not on the system.
Action Copy the missing font onto the system.
IF7102 IPFNTS.SYS file will not open
The IPFNTS.SYS file is not on the system.
Action Create a new IFU IPFNTS.SYS file by executing the IFU IPFNTS
command.
5-24 XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE