Xerox 4635 - Manual (Page 88)

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS1030 Job xxxx has completed printing
The system has finished printing the indicated job.
Action None.
OS1031 Diagnostic print job completed
This message indicates completion of a diagnostic print job.
Action None.
OS1050 Rewind will be done at End-of-Job
When the job has completed processing, the tape will
automatically rewind.
Action None.
OS1061 Initializing CSI
The printer interface board is being initialized to prepare for
operation.
Action None.
OS1062 System mailbox initialized
This is a status message which appears whenever the system is
booted, advising you that the system mailbox feature is being
processed.
Action None.
OS1070 Bar status changing to ON (End Of Report or Task Exit)
The command Bar Off n was entered disabling the barcode
reader for a specified number of sheets but the report ended
prior to reaching n count resulting in the barcode reader being
enabled.
Action None.
OS1072 Bar OFF, n count satisfied, reader is now enabled
The command BAR OFF n was entered disabling the barcode
reader for a specified number of sheets. The count specified as
n was reached and the barcode reader has been enabled again.
Action None.
OS1073 Data1 = nn, Data2 = nn, Data3 = nn, Data4 = nn
This message is for diagnostic purposes only.
Action None.
OS1080 Start accounting report
The REPORT or ACCOUNT command was entered. The system
is compiling and printing, or writing to magnetic tape, a report of
system usage data.
Action None.
6-12 XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE