Xerox 4635 - Manual (Page 115)

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS1975 FCG exiting. Unable to communicate with printer.
A connection between FCG and the LPS printer has failed three
times. This message is followed by message OS1976 PROFILE
NOT LOADED. FCG EXITING: UNABLE TO
Action Contact your supervisor or systems specialist.
OS1979 NVM address . . .
(4050/4090/4650) This message either lists a series of four wire
management or seven third party device parameters for you to
enter or simply gives the current values.
n8 :% wire remaining on spool:
Action 1. Enter the requested wire management parameter values as
appropriate or contact your supervisor or systems specialist.
N
n9 : Stitcher disable
N10 : %low wire
Message threshold: n
or
n1 :Feature control: n
n2 :Skip pitch set: n
n3 :Delay sheet exit: n
n4 :Sheet exit pulse: n
n5 :Delay end of set: n
n6 :End of set pulse: n
n7 :Delay all output:
2. Enter the requested finishing device parameter values as
appropriate.
Notes for device parameter values:
• n1 :FEATURE CONTROL is 0.
• n2 :SKIP PITCH SET is always 1.
• For n3 through n 7 each value is doubled by the system.
(For example, if DELAY SHEET EXIT is equal to 50 milliseconds,
you should specify a value of 25.)
•
n represents a value which corresponds to non-volatile
memory (NVM) locations in the system.
OS1980 Performing print quality adjustment.
This message informs you that print quality adjustment has
started.
Action None.
OS1981 Print quality adjustment has been completed.
This message informs you that print quality adjustment has
completed successfully.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE 6-39